- Start Up & Shut Down for GMP-050
Start-Up
- Check level of materials in containers, making sure level is always over 1/3
- Clean off the dispense manifold with plastic mixer nozzle removed. Pump material into waste container to verify smooth, air-free flow of both materials. Wipe head clean and coat the dispense manifold with compatible lubricant.
- Place new plastic mixer nozzle on applicator block and secure with mixer retainer nut.
Shut-Down
- Turn off motor controller and disconnect the plug from power.
- Remove plastic mixer nozzle and discard.
- Clean head of applicator and coat the threads and tip with compatible lubricant.
- Lubricate grease zerks on applicator head. Fill until the lubricant comes out of the ports (holes) where the mixer is attached. Wipe away any displaced material.
- Lubricate grease zerks on the side of each pump. The chamber being filled is between the shaft seals.
- Lubricate the pump's internal gears:
- Open the end of the bleed valve on the bottom of each pump.
- Fill the zerk on top of the pump until fresh lubricant comes out the hole in the side of the bleed valve.
- Close the bleed valve.
- Verify that tanks are over 1/3 full.
